MOOSE Z950 User Manual download pdf (Page 31)

Fire Supervisory/Trouble (Resetting Smoke Detectors)

Many smoke detectors "latch on" and illuminate a built-in indicator when trig-

gered. This feature allows you to determine which detector caused the alarm. If a

smoke detector remains latched after resetting a fire alarm activation, the yellow

TROUBLE indicator will be lit.

1. Check all smoke detectors for the presence of a latched condition to

determine which detector triggered the alarm. If all detectors appear

normal, a wire may be broken or shorted. Call for service.

2. Press Key 7 and hold for three seconds. The system will attempt to reset

the smoke detectors. If the smoke detector(s) did not reset, the keypad will

continue to indicate the TROUBLE condition. Call your security company

representative for service.

NOTE

If a fire alarm is active, smoke detectors cannot be manually reset until the

fire alarm is reset.

Testing The Fire System

All devices in a Fire Alarm system should be tested monthly except as described

in NFPA 72 chapter 7-3-2. If the Bell Test on page 1-13 does not test the fire

alarm bell, then follow these steps:

1. Notify the Central Station or the appropriate authorities that you are about to

perform a fire system test.

2. Press and hold for three seconds the Keypad Panic Key

(see FIGURE 1-1) that is designated as the Fire Panic Key. The Fire

Alarm should go off.

3. Enter your passcode and press Reset (*) to silence the alarm.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

No comments

MOOSE Z950 User Manual Page 31